• Conductivity Sensor
Conductivity Sensor
Product Serial: Type ICS
  • minimal dead space
  • temperature-compensated evaluation electronics
  • materials and constructional design especially optimised for food applications
  • other material for seal
Conductivity Sensor-ICS
Back to List Inquiry
  GENERAL
Constructional design Ceramic conductivity measuring cell
Product name Conductivity Sensor
Product type ICS-958P3-...
Nominal diameter DN 4
Connection ELSA push-in connectors for pipe/tube OD 6
Ambient temperature 0°C to + 60°C
Medium temperature 0°C to + 140°C
Medium viscosity up to approx. 35 mm²/s
Body material PPSU (KTW- NSF- certified)
Measuring cell material Al₂O₃Pt, glass
O-ring material FKM (FDA-compliant) or EPDM (NSF-, KTW-approved)
Mounting method using spring clip, internal widthØ 30-32 (not included in scope of supply)
Mounting position Preferably upright
Approval NSF/ANSI 169

 

  PNEUMATIC - HYDRAULIC
Nominal pressure PN 16
Pressure range Technical vacuum up to maximum allowable operating pressure OP in accordance with the specifi cation table
Flow rate Kv-value in accordance with the specifi cation table
Medium Gases or liquids which do not corrode the materials specifi ed

 

  ELECTRIC
Supply voltage 9 to 36 VDC
Conductivity output signal 0 to 5 VDC (linear over the entire measurement range)
Temperature output signal 0 to 5 VDC (linear over the entire measurement range)
Electrical Connection 4-pole screened cable 0.75 m (LiYCY 4xAWG24)
Protection class IP65

 

MEASURING CELL Conductivity Temperature
Measuring range 0.2 to 20 mS/ cm 0 to 140°C
Accuracy ± 2% F.S. ± 1°C
Temperature error ± 1% F.S. -
Response time < 1 s < 1 s