Pneumatic Solenoid Valves Manufacturer - Kao Lu
> Products > Medical Biotechnology valve (Medical) > Conductivity Sensor, Type ICS
Product Feature
•minimal dead space
•temperature-compensated evaluation electronics
•materials and constructional design especially optimised for food applications
•other material for seal
Product Specification
GENERAL
Constructional design Ceramic conductivity measuring cell
Product name Conductivity Sensor
Product type ICS-958P3-...
Nominal diameter DN 4
Connection ELSA push-in connectors for pipe/tube OD 6
Ambient temperature 0°C to + 60°C
Medium temperature 0°C to + 140°C
Medium viscosity up to approx. 35 mm²/s
Body material PPSU (KTW- NSF- certified)
Measuring cell material Al₂O₃Pt, glass
O-ring material FKM (FDA-compliant) or EPDM (NSF-, KTW-approved)
Mounting method using spring clip, internal widthØ 30-32 (not included in scope of supply)
Mounting position Preferably upright
Approval
NSF/ANSI 169

 

PNEUMATIC - HYDRAULIC
Nominal pressure PN 16
Pressure range Technical vacuum up to maximum allowable operating pressure OP in accordance with the specifi cation table
Flow rate Kv-value in accordance with the specifi cation table
Medium Gases or liquids which do not corrode the materials specifi ed

 

ELECTRIC
Supply voltage 9 to 36 VDC
Conductivity output signal 0 to 5 VDC (linear over the entire measurement range)
Temperature output signal 0 to 5 VDC (linear over the entire measurement range)
Electrical Connection 4-pole screened cable 0.75 m (LiYCY 4xAWG24)
Protection class IP65

 

MEASURING CELL Conductivity Temperature
Measuring range 0.2 to 20 mS/ cm 0 to 140°C
Accuracy ± 2% F.S. ± 1°C
Temperature error ± 1% F.S. -
Response time < 1 s < 1 s